NOTE:
If battery was disconnected from system board for service, there will be a delay during system boot-up as the
system will undergo RTC battery reset.
Steps
1. Align and place the battery on the palmrest and keyboard assembly.
2. Install the single (M1.6x3.5) and eight (M2x3) screws to secure the battery in place.
3. Reconnect the battery cable to the connector on the system board.
4. Route the wireless antenna cables on the routing guides and adhere the adhesive tape.
Next steps
1. Install the speakers.
2. Install the
base
cover.
3. Install the
SIM card
tray.
4. Install the
microSD
card.
5. Follow the procedure in
Smart card reader
Removing the smart card reader
Prerequisites
1. Follow the procedure in
2. Remove the
microSD
3. Remove the
SIM card
4. Remove the
base
cover.
5. Remove the battery.
6. Remove the speakers.
After working on your
computer.
before working inside your
card.
tray.
computer.
Removing and installing components
41