D-Link DSM-G600 Install Manual page 8

Installing the Hardware
Installing the Hardware (continued)
G. Connect the antenna to
the antenna connector
located on the back of the
DSM-G600.
H. Connect the power adapter
to the power receptor on
the back panel. Then plug
the other end of the power
adapter into a wall outlet or
power strip. The Power LED
will turn on to indicate proper
operation.
Note: When you first power on, the DSM-G600 will offer to format your
hard drive if it is unformatted. This process may take several minutes
depending on the size of your hard drive. During this process, the power
LED will blink. Once the power LED is solid, you may then access the web
based configuration of the DSM-G600. Do not power the unit off during
this process.
8