D-Link DSM-G600 Install Manual page 18

Configuration
Configuration (continued)
When selecting Access Point mode,
you will need to enter the following
network settings:
SSID - Enter the SSID or network
name.
Channel - Select the channel of your
wireless network (1-11).
802.11g Only Mode
if all your wireless devices are 802.11g,
otherwise select Disabled.
SSID Broadcast
allow your SSID to be seen by any
wireless device.
Security - Select to enable WEP, WPA,
or WPA-PSK security.
Click Next.
If you select WEP, enter the following
settings:
Security Mode
Authentication
Encryption Mode
encryption (64 or 128-bit).
Key Format - Select Hex or ASCII.
Default Key - Select which key you want
to use.
Key (1-4) - Enter your WEP key. You may
enter up to 4 different keys.
Enter the same settings on your wireless
clients.
Click Next.
18
- Select Enabled
- Select Enabled to
- Select WEP.
- Select Shared.
- Select the level of