Maintenance - NUTOOL NTC180 Manual

GB
Making a mitre cut
Follow the same procedure for a straight cut but
employ the mitre guide in conjunction with parallel
guide fence (Pic 6). Ensure that the tile is held firmly
into the guide before making the cut.
Cutting with the table at an angle
Loosen the two table securing knobs (front and
rear). Tilt the table to the desired angle using the
scale on the table (Pic 7). Re-secure the table and
make the cut as before.
Changing the blade
Warning!
Disconnect the power supply before making
adjustments or maintaining the machine.
To remove the blade, remove the side cover by
removing the two securing screws (Pic 8),
Hold the end of the blade arbor and remove the
blade-securing nut with suitable wrenches
(Pic 9). Ensure that the arbor and flanges are clean
and re-fit the blade in the opposite manner to
removal.

Maintenance

When all cutting has been completed and before
storing the machine, it is advisable to thoroughly
clean the machine. Empty the water tray and clean
away any tile slurry. Clean the tile cutter with a clean
dry cloth. It is also advisable to give the table and
surface of the machine a light coating of automobile
type wax polish
Technical Specification
Voltage
Motor
No load speed
Diamond blade size
Max. cut at 90°
Max. cut at 45°
Tilting range
Table size
Sound pressure
Sound power
230V ~ 50 Hz
230-240V ~ 50Hz
600 W S2 30 min
550W
2950 min
-1
2800 Min
-1
180 x 22,2mm
180mm x 22.2mm
35mm
34mm
15mm
30mm
0 x 45°
0 x 45°
330 x 360mm
385 x 395mm
L PA 56,7 dB(A)
Lp56.7dB(A)
L WA 69,7 dB(A)
Lw79.7dB(A)
15
20
GB