Starting And Stopping; Making A Cut - NUTOOL NTC180 Manual

GB
Never cut pieces too small to be held securely
against the guide fence without leaving enough
space for your hands to be a safe distance from the
blade.
Ensure that the machine table is clear except for the
tile being cut.
If any pieces become jammed isolate the machine
from the mains supply before clearing the jammed
piece. Never try to remove jammed pieces with the
machine still running.
Never allow the blade to run dry. Failure to keep the
water tray topped up will result in the blade
overheating resulting in damage to the blade and a
Components and controls (Pic 1)
1 On/off switch
2 Diamond cutting blade
3* Mitre cutting guide
4* Parallel guide fence
5 Water tray
Fitting the riving knife/blade guard
Insert the riving knife into the table so that the
threaded section of the knife is under the surface of
the table.
Insert the two securing screws (Pic 2) and align the
knife with the blade ensuring that there is a gap of
no more than 5mm between the blade and the
riving knife. Do not use the machine without the
blade guard fitted.

Starting and stopping

Connect the unit to a power supply of the correct
voltage and frequency (230V 50Hz).
To start the machine press the green button marked
"I" (Pic 3).
To stop the machine press the red button marked
"O" (Pic 3).
N.B This machine is fitted with a "no volt" release
switch. In the event of a mains power failure the
switch will release and will need to be reset when
power is restored. This eliminates the possibility of
the machine starting up unexpectedly.
poor cut in the tile.
Do Not attempt to modify the machine or its
accessories in any way.
Do Not force the machine let the machine do the
work this will reduce the wear on the machine and
blade and increase its efficiency and operating life.
Use approved ear defenders and eye protection
when using this machine.
Wear waterproof protective clothing when using the
tile cutter.
Never use the tile cutter on a decorative surface
unless it is covered with a thick dust sheet and a
plastic waterproof sheet.
6* Blade guard
7 Mains power lead
8 Table tilting knob
9 Work table
10 Parallel guide fence securing knob
Filling the water tray
To remove the tray, slide it outwards until it comes
into contact with the blade housing (Pic 4),
Lift the tray side of the machine until the tray can be
removed completely. Fill the tray to 3/4 full with
water. Do not add chemicals or detergents to the
water. Insert the tray in the opposite manner to
removal.

Making a cut

Adjust the parallel guide fence to the desired width
from the blade using the scale rules on the table
surface for reference. To adjust loosen the two
securing knobs (Pic 5) (one at each end). N.B The
scale rules are for reference only. For improved
accuracy it is advised that a secondary rule should be
used.
Position the tile firmly against the rip fence and pass
through the blade in a smooth action. Do not force
the tile to be cut too quickly.
14
19
GB