Respiratory Protection - NUTOOL NTC180 Manual

GB

Respiratory Protection

When the machining operation creates dust, wear a
dust mask. When machining concrete, man made
fibre boards, especially MDF (Medium Density Fibre
Board) the resin used in these materials can be
hazardous to your health. Use an approved face
mask with replaceable filter.
Dust Extraction Equipment
If the machine is fitted with dust extraction and
collection facilities ensure that these are properly
connected and used.
Do Not Abuse the Power Cord
Never yank or pull on the power cord to disconnect
it from the mains supply socket. Never carry your
power tool by its power cord. Keep the power cord
away from heat, oil, solvents and sharp edges. If the
power cord becomes damaged have it replaced by
an authorised service facility.
Secure the Work Piece
Wherever possible secure the work piece using
clamps or a vice. It is safer than using your hand and
leaves both hands free to control the power tool.
Do Not Over-reach
Do not over-reach, keep proper footing and
maintain your balance at all times.
Maintain Tools with Care
Keep cutting tools sharp and clean for better and
safer performance.
Follow the instructions for lubricating and changing
accessories.
Check the tool power cord periodically and if
damaged have it replaced by an authorised service
facility.
Inspect extension cords periodically and if damaged
replace it.
Keep handles dry, clean and free from oil and grease.
Ensure that ventilation slots are kept clean and free
from dust at all times. Blocked ventilation slots can
cause overheating and damage to the motor.
Disconnect Power Tools
Ensure that power tools are disconnected from the
mains supply when not in use, before servicing,
lubricating or making adjustments and when
changing accessories such as blades, bits and
cutters.
Remove Adjusting Keys and Wrenches
Form the habit of always checking to see that keys
and adjusting wrenches are removed from the
power tool before turning it on.
Avoid Unintentional Starting
Ensure that the switch is in the OFF position before
plugging the power tool into the mains supply.
Extension Cords and Reels
DO NOT use 2 core extension cords or reels on
power tools with an earth path. Always use a 3 core
extension cord or reel with the earth core connected
to earth.
When the power tool is to be used outdoors, use
only extension cords intended for outdoor use and
are so marked.
Always unwind any extension cords fully.
For extension cords upto 15 metres use a wire cross
section of 1.5mm .
2
For extension cords over 15 metres but less than 40
metres use a wire cross section of 2.5mm
Always replace a damaged extension cord before
using it.
Protect your extension cord from sharp objects,
excessive heat and damp or wet locations.
Stay Alert
Watch what you are doing, use common sense, and
do not operate the power tool when you are tired, if
taking medication that causes drowsiness, when
having consumed alcohol or taken drugs.
Check Damaged Parts
Before using the power tool it should be carefully
checked to determine that it will operate properly
and perform its intended function.
12
17
GB
2