Measuring Tape Application - Weston ARROWSAW 52-0601-W Manual

MEASURING TAPE APPLICATION

Electrical Shock Hazard. Before cleaning, assembling, or
w WARNING
disassembling the appliance, make sure the appliance is
OFF( ) and the plug is removed from the outlet/power source.
The Arrowsaw with Dust Collecting Attachment comes without the Measuring
Tape applied. Carefully follow these instructions to apply the Measuring Tape
to ensure you get the best results from your Arrowsaw.
1. Place the Arrowsaw on a flat, level, non-skid work surface.
2. Clean the front face of the Base to remove any dirt or grime that may have
accumulated during manufacturing.
3. Place the end of a tape
measure firmly against the
right side of the Cutting Blade
(FIGURE 3).
4. Measure 6" (15.2 cm) from
the Blade to the back face of
the notch in the Shaft Position
Bracket.
5. Using the left face of the
Shaft Position Bracket as a
guide, mark the Base with a
pencil.
6. Cut the Measuring Tape at
the 5" mark (FIGURE 3).
7. Peel about 4" (10.2 cm)
of the backing off of the
Measuring Tape exposing the
adhesive surface.
8. Line up the 6" indicator line on the Measuring Tape with the left edge of the
Shaft Position Bracket. The top of the Measuring Tape should be about 1/2"
(1.3 cm) below the top of the Base. Carefully apply the Measuring Tape a few
inches at a time. Continue peeling off the backing as necessary.
9. Be sure to apply the Measuring Tape level and without air bubbles
or creases. Such irregularities will result in inaccurate shaft length
measurements.
Right Side
Measuring
of
Tape
Cutting
Blade
Shaft
FIGURE 3
Position
Bracket
Front
Left
Face
Face
of
of Shaft
Base
Position
Bracket
7