Table of Contents
Advertisement
Available languages
Available languages
8. Secure the Blade Shield to the Arrowsaw with the Thumb Screws.
9. Check cutting depth to verify no movement occurred while securing the
Arrow Shaft Guide or replacing the Blade Shield.
10. Verify the On/Off Power Switch is in the "OFF" position and connect the
Arrowsaw to the power source. Turn the attached vacuum on.
11. Turn on the Arrowsaw and allow a few seconds for the Motor to reach full
speed.
WARNING: ALWAYS stand clear of the Cutting Blade during start up.
12. Gently guide the arrow shaft into the Cutting Blade. Rotate the arrow shaft
until it is completely cut (FIGURE 11).
13. Carefully remove the cut arrow shaft from the Arrow Shaft Guide and
Shaft Position Bracket. Be careful to not allow the arrow shaft to further
contact the Cutting Blade.
14. Turn the Arrowsaw to the 'OFF' Position. Turn off the attached vaccuum.
Disconnect from the power source when not in use.
FIGURE 11
Cutting Blade
Shaft Position
Arrow Shaft
Bracket
Arrow Shaft
Guide
12
Advertisement
Table of Contents
