Table of Contents
Advertisement
Available languages
Available languages
ARROWSAW BLADE REPLACEMENT
w WARNING
Your Arrowsaw comes complete with two,
reinforced Cutting Blades. These Cutting
Blades are ideal for cutting both carbon and
aluminum arrow shafts. To order replacement
Cutting Blades, contact Customer Service at
the telephone number listed on the back of this
manual.
1. Set the On/Off Power Switch to the "OFF"
position. Disconnect the Power Cord from the
power source.
2. Loosen the two Thumb Screws holding the
Blade Shield to the Arrowsaw (FIGURE 13).
3. Remove the Thumb Screws and Cutting
Blade Shield.
4. Remove the Socket Head Cap Screw
securing the Arrow Shaft Guide to the Base
(FIGURE 14).
5. Remove the Arrow Shaft Guide.
6. Insert the long leg of the largest Allen
Wrench supplied with your Arrowsaw into one
of the holes in the outer edge of the Blade
Mounting Bracket (FIGURE 15).
7. Place the Wrench onto the Blade Retaining
Nut. While holding the Allen Wrench, loosen
the Blade Retaining Nut (rotate counter
clockwise) until you can remove it by hand.
8. Remove the Blade Retaining Nut, Blade
Spacer and Cutting Blade.
9. Carefully install a new Cutting Blade.
CAUTION: NEVER USE A BROKEN, WORN
OR CRACKED BLADE!
10. Re-install the Blade Spacer and Blade
Retaining Nut.
11. Re-install the Arrow Shaft Guide and Blade
Shield. CAUTION: NEVER OPERATE THE
Arrowsaw WITHOUT THE BLADE SHIELD
SECURELY MOUNTED IN PLACE!
The Arrowsaw Cutting Blade rotates at very
high speeds. It is normal for the Arrowsaw
to vibrate during operation. If you experience excessive noise and/or vibration
during operation, or blade breakage, check all parts to ensure they are properly
and securely mounted. If the problem continues, please contact Customer
Service.
14
Electrical Shock Hazard. Before cleaning, assembling, or
disassembling the appliance, make sure the appliance is
OFF( ) and the plug is removed from the outlet/power source.
Blade Shield
Arrow Shaft
Thumb Screws
Guide
Arrow Shaft
Guide
Blade
Cutting
Mounting
Blade
Bracket
Blade
Allen
Retaining
Wrench
Nut
Blade
Spacer
FIGURE 13
FIGURE 14
Cutting
Blade
Base
Socket Head
Cap Screw
FIGURE 15
Wrench
Base
Advertisement
Table of Contents
