Table of Contents
Advertisement
Adjusting the Height of the Image
Foot release
Projector
2
3, 4
1, 5
Pressing ∂ ∂ ∂ ∂ ∂
in Step 2
On-screen Display
3
3
3 Test Pattern
3
3
VOL
ON
MUTE
OFF
BLACK
SCREEN
LASER
MENU
TOOLS
6
R-CLICK
ENTER
INPUT
IrCOM
FREEZE
AUTO SYNC
KEYSTONE ENLARGE
MOUSE
ADJ.
LIGHT
Pressing ƒ ƒ ƒ ƒ ƒ
in Step 2
4
4
4
4
4
g
Using the Adjustment Foot
You can adjust the height of the image by raising
the projector with the foot release.
1 Press the foot release and lift the projector to the
desired angle.
2 Remove your hand from the foot release. Once
the adjustment foot has locked in position, release
the projector.
Returning the projector to its original position
While holding the projector, press the foot release and slowly
lower the projector to its original position.
• The projector is adjustable up to approximately 5° from the
standard position.
• When an adjustment is made, the image may become
distorted (keystoned), depending on the relative positions
of the projector and the screen.
CAUTION
• Do not press the foot release when the adjustment foot is
extended without firmly holding the projector.
• Do not hold the lens when lifting or lowering the projector.
• When lowering the projector, be careful not to get your
fingers caught in the area between the adjustment foot and
the projector.
Digital Keystone Correction
When the image is distorted due to the projection
angle, the Digital Keystone Correction function
allows you to correct it.
(For use with the "Power" remote control, slide the
MOUSE/ADJUSTMENT switch to the ADJ. position.)
1 Press KEYSTONE.
2 Press ∂ to compress the upper part of the image.
Press ƒ to compress the lower part of the image.
3 Press ENTER to display a test pattern.
4 Press ENTER to clear the test pattern.
5 To exit, press KEYSTONE.
6 To reset, press LEFT-CLICK.
• Straight lines or the edges of the displayed image may
become jagged.
MOUSE
ADJ.
14
Advertisement
Table of Contents
