Stingr Serial Test Commands; Transmitter Test" Command - Globalstar STINGR User Manual

5.2.4 STINGR Serial Test Commands

5.3 "Transmitter Test" command

This command is used to initiate a transmitter test in one of three modes.
Byte
0
1
2
3
4 – 5
Example Command: AA 06 FC
Where:
Test Mode:
•
Revision 0.2
06/24/15
Revision 0.2
Transmitter test command format
Bits Parameter
0 - 7 Leader
0 - 7 Length
0 - 7 Command Code.
0 - 7 Test mode
0 - 15 CRC
Leader Len
AA 06
02 2E A2
0x02 = Single Test Packet
Subject To Change without Notice
STINGR Users Manual
Description
Always a value of 0xAA.
0x06
0xFC = Transmitter test.
The following test modes may be selected:
0x01 = CW Mode
0x02 = Transmit single test packet.
0x03 = Mod mode.
signal modulated with a bit pattern.
Test
Cmd Mode CRC1
02
FC 2E
Transmit a continuous
CRC2
A2
P a g e | 27