Attaching The Assembled Solenoid And Pilot Valve To The Flange Compartment - Hunter G835 Owner's Manual

ATTACHing THe ASSeMbled Solenoid And PiloT VAlVe To THe flAnge CoMPARTMenT

With the solenoid and pilot Valve correctly assembled as outlined above, look at the bottom of the pilot Valve. notice
there are two opposing sections of plastic that protrude to the outside and away from the center (fig 139). these two
"ears" must engage the Pilot Valve's mounting base in the body flange compartment during installation (fig 140).
To install the Solenoid and Pilot Valve, first position yourself to the side of the rotor such that the rotors flange
compartment is at the 6:00 position (closest to you). next, lower the solenoid and pilot Valve assembly (fig 141) into
the flange compartment with the Pilot Valve's fittings pointing to the left side (9:00 position). Engage the bottom of
the Pilot Valve with the Pilot's Valve's mounting base located at the right and rear of the flange compartment. Press
down to engage pilot Valve's mounting ears (fig 142).
49
FIg 139
Fig
Fig
138
138
FIg 141
Fig 140
Fig 140
FIg 140
Fig
Fig
139
139
FIg 142
Fig 141
Fig 141