Attaching Selector Cap To The Solenoid; Pressure Regulator Purpose Settings And Adjustment Procedures; Pressure Regulator Adjustment - Hunter G800 Series Owner's Manual

ATTACHING SELECTOR CAP TO SOLENOID I TABLE OF CONTENTS

ATTACHING SELECTOR CAP TO THE SOLENOID

The Selector Cap turns the Solenoid when the user changes the ON-AUTO-OFF settings. Under
normal operating conditions, the Selector Cap should not need replacement. The Selector Cap can
become damaged if the incorrect tool is used to make ON-AUTO-OFF selection adjustments.
With the Solenoid and Pilot Valve assembly installed in the flange compartment and the Solenoid
set to the Auto position (see instructions above), proceed as follows. The flat side of the Solenoid
should be facing away from the rotor's riser assembly pointing towards the outside of the flange
compartment (FIGURE 142).
Starting from where the Solenoid's lead wires come out of the top of the Solenoid, place the lead
wires side-by-side over the top and down the flat side of the Solenoid (FIGURE 143). While holding
the Solenoid's lead wires in this position, place the Selector Cap on top of the Solenoid. The
Selector Cap must be oriented such that the Solenoid's lead wires fit into the recessed channel
on the inside wall of the Selector Cap. Press the Selector Cap down and onto the Solenoid
(FIGURE 144).
FIGURE 143 FIGURE 144
Fig
Fig
142
142
PRESSURE REGULATOR PURPOSE, SETTINGS AND ADJUSTMENT PROCEDURES
Regulation settings are preset at the factory. If the installed rotor has been preset to the specified
regulation setting for your irrigation system, further Pressure Regulator adjustments are not
normally necessary. If a replacement TTS rotor is being installed, it may be necessary to adjust the
regulation setting.
Pressure Regulator Purpose – The purpose of the Pressure Regulator (FIGURE 145) is to ensure
that a specifically set pressure is supplied to the rotor's nozzles. Since the amount of flow through
the nozzles is affected by pressure, supplying a consistent pressure to every rotor in the irrigation
system is beneficial. This will help to ensure that all rotors with the same size nozzles will have the
same application rate (also known as the precipitation rate).
55
Fig
Fig
143
143
TABLE OF CONTENTS I
Pressure regulation also prevents too much
pressure from reaching the nozzles. Rotors
that are closer to the pump station or rotors
that are at a lower elevation will have relatively
higher pressures than rotors that are at the
far reaches of the irrigation system's piping or
those at higher elevations. Abnormally high
pressures at the nozzles can cause misting of
the water droplets. Water that is misting will
be easily carried away from its intended target
by the wind.
Fig
FIGURE 145
144

PRESSURE REGULATOR ADJUSTMENT

The variable setting Pressure Regulator has
been calibrated from the factory and set to a
specific regulation setting. This setting will not
normally need to be changed. The variable
Pressure Regulator has a pointer and a pressure
indicating scale on the side of its body with a
range of 60 PSI to 120 PSI. If pressure setting
adjustments are required, it is important to note
the following:
Learn more. Visit hunterindustries.com/golf
PRESSURE REGULATOR ADJUSTMENT
Pressure Regulator Settings – All electric
valve-in-head TTS rotors have adjustable Pressure
Regulators. One of the many beneficial features
of the TTS rotor is the fact that the Pressure
Regulation is conveniently adjustable yet hidden
within the flange compartment. This prevents
untrained personnel or golfers from shutting
down a rotor during operation and inadvertently
changing its regulation setting.
The calibrated pressure setting from the
factory is very accurate. However, the pressure
indicating scale is only a pressure setting
reference when making adjustments in the
field. For more precise pressure regulation
adjustment in the field, use a pitot gauge at the
nozzle to the check pressure.
56