Cisco MDS 9220i Manual page 14

Installing the Switch into a 2-Post Rack

Figure 7: Installing Rack-mount Brackets on the Rear Side of the Chassis

c) Repeat Step 1b, for the other front rack-mount bracket on the other side of the switch and be sure to position that

bracket the same distance from the front of the switch.

Note

Install the NEBS air-baffle onto the switch in case of port-side intake. For more information, see

Compliance, on page

Step 2

Install the switch onto the 2-post rack:

a) Holding the switch with both hands, position the back of the switch between the two posts of the rack. Then gently

move the switch until the front rack-mount brackets come in contact with two rack posts.

b) Holding the chassis level, insert two screws (12-24 or 10-32, depending on the rack type) into each of the two front

rack-mount brackets (using a total of four screws) and into the cage nuts or threaded holes in the vertical rack-mounting

posts.

Installing the Cisco MDS 9220i Switch

NEBS

Table of Contents