Dishwasher Detergent; Adjusting The Rinse Aid Setting; Choice Of Detergent; Filling The Detergent Dispenser - Cooke & Lewis CLSLDISHUK Manual

IMPORTANT: Soak up any spilt rinse aid with a damp absorbent cloth to avoid excess
foaming during the next wash cycle.

Adjusting the Rinse Aid Setting

The rinse aid dispenser has six settings, and is factory set at 5.
This will be the correct setting in most cases.
However, if there are drops of water remaining on the dishes
after washing, the rinse aid use can be increased by turning the
arrow head anti-clockwise.
If there are white streaks on the dishes after washing, the rinse
aid use can be reduced by turning the arrow head clockwise.
To adjust the setting, first turn the rinse aid container cap anti-
clockwise 90°and remove it. Adjust the arrow head with a small
flat head screwdriver and replace the cap by turning it clockwise
90° to lock.
04

Dishwasher Detergent

Choice of Detergent

Ensure you only use detergent in powder or tablet form suitable for dishwashers and always follow the manufacturer's guidelines
on the amount to use. Occasionally, tablets may not fully dissolve and be completely used on the shortest rapid wash cycle, so it is
recommended that powder is used for this program.

Filling the Detergent Dispenser

1
To open the detergent lid, move the lever upwards to the right and the lid will spring open. Once the correct detergent has been
placed in the container close the lid by pressing the lid onto the case until it clicks shut. Always add the detergent just before
starting each wash cycle.
If the dishes are heavily soiled and you are using powder detergent, place the powder in both compartments. The main
wash compartment is marked 1 and the pre-wash compartment is marked 2 (see diagram). Place tablets in the main wash
compartment only.
GALA11122 45cm Slimline Dishwasher IM V6R Combined.indd 37
2
37
16/10/2019 15:19