Getting Started With Speedcapture; Getting The Speedcapture App From The App Store; Pairing A Phone To The Laser - Laser Technology LaserSoft SpeedCapture User Manual

Copyright © [2013] Laser Technology, Inc. All rights reserved. Unauthorized duplication, in whole or in part, is strictly prohibited.

2. Getting Started with SpeedCapture

This chapter describes the basic knowledge necessary to get started with SpeedCapture. It explains how to get the
SpeedCapture app from the App Store and launch the app. Once the application has been successfully launched,
follow the directions in this chapter to use the main menu and configure the settings.

Getting the SpeedCapture App From the App Store

To get the SpeedCapture app from the App Store:
1. Use the App Store search function to search for "SpeedCapture".
Tap the SpeedCapture icon to install the app as you would for any other iOS application.
2.

Pairing A Phone to the Laser

To ensure a phone is properly communicating with the laser, it must be connected with Bluetooth. To begin this process,
verify that the laser is powered on and within range:
1. Find and tap the Settings icon on the phone.
2. Tap Bluetooth on the Settings list (Figure 2). If Bluetooth is listed as "OFF," toggle it to "ON."
3. Tap the laser device's serial number. You should see it listed among the other devices you connect via Bluetooth on
your phone (Figure 3). Within a few seconds, the laser should be described as "Connected" (Figure 4). Now you are
ready to begin using the SpeedCapture app with the laser.
Figure 2
NOTE If the laser is powered off when viewing the current or available Bluetooth connections on a phone, the laser device may
be described as "Not Connected" even if the two have already paired. Power the laser on and tap the device serial number to
re-establish that connection. Sometimes more than one attempt is necessary when establishing the Bluetooth connection
between the laser and the phone. It may be necessary to "forget" the laser device from the Bluetooth list and then
re-pair them or totally shut down and restart the phone.
LaserSoft SpeedCapture User's Guide 1
When the TruSpeed device
is powered on, your iPhone
will recognize it and list the
device serial number, but
describe the connection as
"Not Paired."
st
Edition for iOS
To pair the device with
your iPhone, tap the device
serial number.
Within a few seconds, the
screen should appear as
shown here.
Figure 3
3
Figure 4