Advertisement
Available languages
Available languages
5. MALFUNCTION
Should the machine fail to function correctly,
a number of possible causes and the
appropriate solutions are given below:
AIR LOSS
• May be caused by a poor seal of a connection.
• Check all connections by wetting them with
soap and water.
The compressor runs but does not compress
• May be caused by the valves (C-C2) or a
gasket (B1-B2) being broken.
• Replace the damaged part.
THE COMPRESSOR WILL NOT START
• If the compressor is difficult to start, check:
• whether the voltage of the mains corresponds
to that on the specification plate
• whether electrical extension cables are
being used with a faulty core or length.
• whether the operating environment is too
cold (below 0°C).
• whether there is electricity supply (plug
properly connected, magneto-thermal fuses
not broken).
The compressor does not shut off If the
compressor does not shut off when the
maximum pressure has been reached, the
safety valve of the tank will be activated. It is
necessary to contact the nearest authorised
6. SUPPORT SERVICE FOR THE REPAIR.
Repairs and servicing should only be carried
out by a qualified technician or service firm.
7. CLEANING
Regularly clean the machine housing with a
soft cloth, preferably after each use. Keep the
ventilation slots free from dust and dirt.
If the dirt does not come off use a soft cloth
moistened with soapy water. Never use
solvents such as petrol, alcohol, ammonia
water, etc.
These solvents may damage the plastic parts.
8. LUBRICATION
It is recommended to disassemble the
suction filter every 50 operating hours and
to clean the filter element by blowing it with
compressed air.
It is recommended that the filter element is
replaced at least once a year if the compressor
is working in a clean environment; more often
if the environment in which the compressor
is situated is dusty. The compressor makes
condensed water which collects in the tank.
It is necessary to remove the condensed
water in the tank at least once a week by
opening the drain cock under the tank. Take
care when compressed air is in the bottle
because the water can come out with some
force. Recommended pressure max. 1-2 Bar.
9. DISPOSAL.
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
The
plastic
labelled for categorized recycling. Do not
dispose of power tools into household waste!
According the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment
and its implementation into national right,
power tools that are no longer usable must
be collected separately and disposed of in an
environmentally correct manner.
13
components
are
Advertisement
