Generator Shutdown Procedure - MQ Power WHISPERWATT Series Operation Manual

WARNING
NEVER stop the engine suddenly except in an
emergency.
NORMAL SHUTDOWN PROCEDURE
To shutdown the generator, use the following procedure:
1. Place both the MAIN, GFCI and LOAD circuit breakers
as shown in Figure 35 to the OFF position.
Figure 35. Main, Aux. and GFCI
Circuit Breakers (OFF)
2. Place the speed control switch to the LOW (down)
engine speed position as shown in (Figure 36) and let
the engine cool for 3-5minutes with no load applied.
Figure 36. Engine Speed Switch (Low)
3. Turn the ignition key counterclockwise to the STOP
position. When the engine has stopped, remove key.
Place key in a safe place where it will not be lost.
Figure 37. Ignition/Starter Switch (Stop)
4. Remove all loads from the generator.
5. Inspect entire generator for any damage or loosening of
components that may have occurred during operation.
DCA15SPXU4F • OPERATION MANUAL — REV. #1 (02/10/17) — PAGE 29

GENERATOR SHUTDOWN PROCEDURE

EMERGENCY SHUTDOWN PROCEDURE
1. Turn the ignition key counterclockwise to the STOP
2. Place both the MAIN, GFCI and LOAD circuit breakers
Emergency Stop Switch (Option)
1. If equipped (option), push the Emergency Stop
AUTOMATIC SHUT-DOWN SYSTEM
This unit is equipped with safety devices to automatically stop
the engine in the event of low oil pressure, approximately
7.1 psi (49 kPa), or high water temperature, approximately
234°F (112° C), overspeed approximately (2,070 rpm).
The alarm lamps on the Engine Warning Lamp Module
(Figure 4, item 4) illuminate to signify the reason for the
engine shutdown.
position. When the engine has stopped, remove key.
Place key in a safe place where it will not be lost.
as shown in Figure 35 to the OFF position.
Pushbutton Switch (Figure 38).
Figure 38. Emergency Stop Button