Remote Control By Text Messages; Controls; Control Commands; 44 "W" - Wallas Heater Control - wallas 4430A Installation And Operation Instruction Manual

D30061

Remote control by text messages

The 4430 unit can be controlled remotely by sending text messages to the unit by
phone.
The unit has a number of commands for guiding the process. Each command is
dif-ferent and contains a letter, which assigns a property to the text message. In
addi-tion to letters, numbers 1 and 0 are used as abbreviations for the ON/OFF
function. The setting can vary, but they are explained in this section.
Note that one text message can contain a combination of several commands.
General preconditions for sending a text message:
• Use the phone and write your text message.
• Start the text message with the default code 1234, and then write the com-
mand.
• Send the message to the telephone number assigned to the SIM card of the
4430 unit.

Controls

S Status message.
W Wallas heater control.
NOTE:
Spaces are permitted between commands, but PROHIBITED in the middle of a
command.
"1234 W1 S4" is CORRECT, "1234 W 1 S 4" is INCORRECT.

Control commands

"W" – Wallas heater control
Text message commands
S4 Status command
W0 Turn the Wallas heater off (stop)
W1 Turn the Wallas heater on (start)
W2xx Set the Wallas heater temperature.
Note:
The W2 command must be sent AFTER the W0 or W1 command.
W2 can be programmed within the range of +5 – +35°C. Note that the character +
does not have to be used for controlling a Wallas.
Example:
"1234 W230" means that the temperature of Wallas is 30°C.
It takes 15 seconds from the moment of entering the command to update the S4
data. Therefore it is recommended that the ON/OFF OFF/TEMPERATURE com-
mands are sent separately with an interval of at least 15 seconds.
4430A
Operation
- 44 -
en
490538A