Page 1
Trend Podium Desk ASSEMBLY INSTRUCTIONS INSTRUCCIONES DE ENSEMBLAJE INSTRUCTIONS DE MONTAGE DO NOT THROW AWAY! NO LA TIRE NE PAS JETER UPDATED AS OF: 09/21/2021 1 of 7...
Parts List Hardware P1 - Table Top A - M6 x 15mm Screw B - M6 x 42mm Screw P2 - Leg C - Locking Caster D - Non-Locking Caster P3 - Modesty Panel E - Lock Washer P4 - Long Angle Support F - Allen Wrench G - Caster Wrench P5 - Short Angle Bracket...
WARNINGS AND DISCLAIMERS ADVERTENCIAS Y RENUNCIAS AVERTISSEMENTS Review full assembly instructions and Previo a comenzar el proceso de Avant de commencer l’ assamblage check that all parts are present before ensamblaje favor revisar veuillez consulter instructions beginning assembly. Heavy or large instrucciones y asegurarse que cuenta con complètes et vérifier si vous avez toutes furniture may require multiple persons in...
Page 4
STEP 1 Place a Lock Washer (E) on the threaded stem of the Locking Caster (C) and screw it into the front Leg(P-2). Tighten with Caster Wrench (G). Place a Lock Washer (E) on the threaded stem of the Non-Locking Caster (D) and screw it into the rear Leg (P-2) and tighten with Caster Wrench (G) as shown in illustration #1.
Page 5
STEP 3 Attach the Modesty Panel (P-3) to the Leg (P-2) using three Screws (A) as shown in illustration #3. Tighten with Allen Wrench (F). Attach the Long Angle Supports (P-4) to the threaded insert under the cut-out of the STEP 4 Desk Top (P-1) using three Screws (A).
Page 6
STEP 5 Attach the Trend Desk #58229 assembly from Step #5 to the Trend Podium #58230 assembly using the extra hardware from the Trend Desk #58229. Attach the Modesty Panel (P-3) to the Podium’s Back Panel using two Screws (B) through the bottom two holes in the Modesty Panel and into the the bottom threaded inserts in the Podium’s...
Page 7
STEP 7 Use three Screws (A) through the Long Angle Support (P-4) that is attached to the bottom of the Table Top (P-1) and into the threaded inserts that are attached to the Left Side Panel of the Podium. 7 of 7 UPDATED AS OF: 09/21/2021...