Advertisement
Assembly
continued.
Step 6
Install post onto post base.
Decal on post should face front
of heater (see photo on front
cover).
Step 7
Load cover onto post.
(For models without a table, skip to Step 12)
Step 8
Insert table supports into the receptors located in the underside of the
table frame.
NOTE: Screws must be backed out of the support tubes. Use those
screws to attach the clamp in the next step.
Support Tube
6
Attach post to post base using four
large screws.
Tighten screws securely.
4 Required
Large Screw
Slide cover down.
Step 9
Using the three screws removed in Step 8, securely attach clamp
assembly to support tubes.
Step 10
Load table onto post by sliding
table clamp over post and feed post
through center hole of table.
Slide table to desired position.
Step 11
Tighten clamp so table is secured to the post.
Friction Sleeve (between
clamp and post)
Gap in Sleeve should be
opposite gap in clamp
3 Required
Small Screw
Advertisement
