Advertisement
Operation
continued.
Match Lighting Instructions for LIGHT
1. Turn cylinder valve on.
3. Place a lighted match near mantle, then push in and rotate Light
Control Knob to the ON position. Immediately light second mantle with
match.
Note: If BOTH mantles are not lighted within 5 seconds, turn Light
control knob to OFF position. All controls should be turned to the OFF
position and a period of at least 5 minutes should pass before
reattempting to light mantles.
4. Carefully replace front glass.
12
2. Remove front glass.
Shut Down Procedure
HEATER
1. Rotate Heater control knob
(clockwise) to pilot position.
2. Push in on Heater control knob
and rotate (clockwise) to OFF posi-
tion.
The gas supply must be turned off at the LP-gas cylinder when this
appliance is not in use.
Storage
Disconnect heater from propane tank before long
term storage of either the cylinder or the Heater.
1. Turn cylinder valve off.
2. Disconnect regulator from cylinder.
3. Remove tank from Heater.
4. Store propane tank in safe manner. Refer to Chapter 5 of Standard for
Storage and Handling of Liquefied Gases, ANSI/NFPA 58 . Follow all
local codes. Always store propane tanks outdoors.
5. Store heater in a dry, clean, and safe place.
WARNING
• BURN HAZARD
• Do not touch or attempt any maintenance on Heater for at least 1
hour after use.
• Make sure all controls are off and propane tank has been removed
before doing maintenance.
Maintenance
To enjoy years of outstanding performance from your Heater perform
the following maintenance activities on a regular basis:
• Keep exterior surfaces clean.
• Use warm soapy water for cleaning. Never use flammable or cor-
rosive cleaning agents. For stainless steel surfaces, use a stain-
less steel cleaner available at most retail stores.
• While cleaning your unit, be sure to keep the area around the
burner, pilot assembly and mantle area dry at all times. If the reg-
ulator is exposed to water in any way, do NOT try to use it. It must
be replaced.
• Air flow must be unobstructed. Keep controls, burner, and circu-
lating air passages clean. Signs of possible blockage include:
• Gas odor with extreme yellow tipping of flame.
• Heater does NOT reach the desired temperature.
• Heater glow is excessively uneven.
• Heater makes popping noises.
• Light is uneven or burns with a yellow smokey flame.
• Spiders and insects can nest in burner orifices. This condition
can damage heater and render it unsafe for use. Clean burner
holes by using a heavy-duty pipe cleaner. Compressed air may
help clear away small particles.
• Carbon deposits may create a fire hazard. Clean light and burner
with warm soapy water if any carbon deposits develop.
• NOTE: In a salt-air environment (such as near an ocean), corro-
sion occurs more quickly than normal. Frequently check for corrod-
ed areas and repair them promptly.
LIGHT
1. Push in and rotate Light control
knob (clockwise) to OFF position.
Advertisement
