Download Print this page

FSR SW-STK-1P1D Assembly Instructions

SW-STK-1P1D STICK ASSEMBLY INSTRUCTIONS

244 Bergen Boulevard, Woodland Park, NJ 07424, Phone 973.785.4347 - Fax: 973.785.4207

STEP 1:

Install the plastic raceway edges in the track base.

1. Install in the outer track as shown.

2. Have the plastic edge hang out one side by 3 or 4 inches.

3. Tap the edges in with rubber mallet or bottom of a rubber coated hammer handle.

STEP 2:

Next, press the wired device box onto the extended plastic edging with the cord facing onto the track,

then slide the device box tabs into the bottom slot on the track base only an inch or two.

STEP 3:

Run the power cord down the length of the raceway and out the end opposite the device box. Add

any additional low voltage wires required by feeding them through the brush on the device box. Insert

wiring clips as required (5 provided) to hold the wires in place.

43431

Alignment

Rails

Wiring Clip

Patent No. 10,862,283

3"-4"

Box Tabs

User Supplied Low Voltage Cable

Device

LIT1823A

Table of Contents

Need help?

Do you have a question about the SW-STK-1P1D and is the answer not in the manual?

Page 1 SW-STK-1P1D STICK ASSEMBLY INSTRUCTIONS 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone 973.785.4347 - Fax: 973.785.4207 Patent No. 10,862,283 STEP 1: Install the plastic raceway edges in the track base. 1. Install in the outer track as shown. 2. Have the plastic edge hang out one side by 3 or 4 inches.
Page 2 STEP 4: Slide the tabs of the cable exit bracket into the bottom slot on the track base, opposite the device box, making sure all the wires that need to exit the track are passed through the bracket legs. STEP 5: Make sure the plastic edges are now back in place, pushed tight against the cable exit bracket.