FSR FLH20-0-BX Installation Manual

COVER INSTALLATION
INSTALL BOX-ATTACHED CHAIN TO COVER, AND REPLACE COVER
BACK INTO NEWLY-INSTALLED RIM, LATCHING THE SMALL DOORS
IN PLACE (REVERSE ACTIONS OF DETAILS 1 THRU 3 PREVIOUSLY
DONE). CHAIN FROM BOX CAN BE REMOVED AND INSTALLED TO
ALTERNATE LOCATION, IF DESIRED.
BRACKET FOR STORING
SMALL DOOR WHEN
REMOVED FROM COVER
COVER
#8-32 PAN HEAD SCREW
CONCRETE SURFACE
STUD FOR ALTERNATE
LOCATION OF CHAIN
CHAIN FROM BOX
FSR Inc.
244 Bergen Boulevard, West Paterson, NJ 07424
Phone: 973.785.4347 - Fax: 973.785.4207
Web: www.fsrinc.com - E-mail: sales@fsrinc.com
FSR
244 Bergen Boulevard, West Paterson, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
FLH20-0-BX/FLH20-0S-C Installation Guide
BOX INSTALLATION - STEP 1
REMOVE AND RETAIN TEMPORARY COVER AND SCREWS.
LOCATE AND POSITION BOX IN ACCORDANCE WITH
FLOOR PLANS. TOP EDGE OF BOX MUST BE FLUSH WITH
CONCRETE POUR. LEVEL AND ANCHOR BOX AS REQUIRED.
USE SCREWS, NAILS, OR WIRE TO PREVENT BOX FROM
FLOATING DURING POUR. ROUTE CONDUITS TO BOX AS
REQUIRED. PLACE THIS INSTALLATION GUIDE BACK INTO
BOX, ALONG WITH ALL SUPPLIED ITEMS, AND REINSTALL
TEMPORARY COVER.
TEMPORARY COVER
(4) #8-32 FLAT HEAD SCREW
TOP EDGE TO
BE FLUSH WITH
CONCRETE
CENTER DIVIDER CONFIGURATION
SET ASIDE TEMPORARY COVER AND SCREWS FOR POSSIBLE RE-INSTALLATION.
REMOVE AND RETAIN GANG MOUNTING BRACKETS AND SCREWS TO CONFIGURE
CENTER DIVIDERS.
(10) #8-32 PAN HEAD SCREW
GANG MOUNTING BRACKET
43134
BOX INSTALLATION - STEP 2
SCREED TO TOP OF BOX SURFACE. HAND TROWELING
RECOMMENDED NEAR BOX EDGES. BOX HAS NO
HEIGHT ADJUSTMENT AFTER CONCRETE POUR.
CONCRETE SURFACE
REMOVABLE LARGE CENTER DIVIDER
REMOVABLE SMALL
CENTER DIVIDER
GANG MOUNTING BRACKET
REMOVABLE SMALL
CENTER DIVIDER
REMOVABLE LARGE CENTER DIVIDER
C-1059 LIT1235