Advertisement
Table of Contents
- 1 Drill 3.50" Diameter Hole in Table Top.
- 2 Insert HV-T3 Assembly and Orient as Required.
- 3 Slots Used for 5/8" to 1-1/8" Thick Table Tops.
- 4 Slots Used for 1-1/8" to 1-9/16" Thick Table Tops.
- 5 HV-T3 Assembly
- 6 Mounting Clamp and Mounting Screw Installed
- 7 HV-T3 Table Box Cable Harness Detail
- Download this manual
FSR
HV-T3 INSTALLATION INSTRUCTIONS
244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207
1.
DRILL 3.50" DIAMETER HOLE IN TABLE TOP.
2. INSERT HV-T3 ASSEMBLY AND ORIENT AS REQUIRED.
3. INSTALL MOUNTING CLAMPS TO ASSEMBLY AND SECURE TO TABLE BY
SCREWING MOUNTING SCREWS TO UNDERSIDE OF TABLE.
4.
MAKE ELECTRICAL CONNECTIONS AS REQUIRED. ENSURE HDMI
CONNECTOR CAN BE PULLED OUT 3'-0".
3.50" DIAMETER
43045
HV-T3 ASSEMBLY
MOUNTING
CLAMP AND
MOUNTING
SCREW
INSTALLED
TABLE
CUSTOMER TO PROVIDE
KO SLUG/PENNY/OTHER
HARD FLAT PIECE FOR
SCREW END, WITH SOFT
SLOTS USED FOR 5/8" TO
1-1/8" THICK TABLE TOPS
SLOTS USED FOR 1-1/8" TO
1-9/16" THICK TABLE TOPS
(2) MOUNTING
CLAMP
(2) MOUNTING
SCREW
TABLE WOOD
MOUNTING
CLAMP AND
MOUNTING
SCREW
(SEE BELOW)
LIT1468A
Advertisement
Table of Contents
Related Manuals for FSR HV-T3
Summary of Contents for FSR HV-T3
- Page 1 244 Bergen Boulevard, Woodland Park, NJ 07424, Phone: 973.785.4347 - Fax: 973.785.4207 DRILL 3.50" DIAMETER HOLE IN TABLE TOP. 2. INSERT HV-T3 ASSEMBLY AND ORIENT AS REQUIRED. 3. INSTALL MOUNTING CLAMPS TO ASSEMBLY AND SECURE TO TABLE BY SCREWING MOUNTING SCREWS TO UNDERSIDE OF TABLE.
Need help?
Do you have a question about the HV-T3 and is the answer not in the manual?
Questions and answers