Toshiba MMK-UP0271HP-E Installation Manual page 14

Installation diagram of Indoor and outdoor units
Flat head
wood
screw
Remote control
holder
Before installing the wireless remote controller
1. Remove the battery
cover.
2. Insert 2 new batteries
(R03 [AAA] type)
following the (+) and (−)
positions.
Installation space
The indoor unit shall be installed at least 2.5 m height.
Also it must be avoided to put anything on top of the indoor unit.
*1 Reserve space required to install the indoor unit and for service work.
Keep 50 mm or more for clearance between top plate of the indoor unit and the ceiling surface.
*2 Provide a space as shown for service clearance for the cross flow fan.
Installation place
• A place which provides the spaces around the indoor unit as shown in the above diagram.
• A place where there is no obstacle near the air inlet and outlet.
• A place that allows easy installation of the piping to the outdoor unit.
• A place which allows the front panel to be opened.
13-EN
Hook
Installation plate
Heat insulator
Wireless Batteries
remote
controller
Cover
For the rear left, bottom left and left piping
Hook
Split out 2 pieces of SPACER from indoor unit
packing material, insert between the indoor unit and
wall to tilt the indoor unit for better operation.
The auxiliary piping can be connected to the left,
rear left, rear right, right, bottom right or bottom left.
Shield pipe
Make sure to run
the drain hose
sloped downward.
Refrigerant piping must be protected from physical
damage. Install a plastic cover or equivalent.
Insulate the refrigerant pipes separately with
Wireless
remote controller
Batteries
6 mm thick heat resisting polyethylene foam
‒ 13 ‒
Installation Manual
Wall
Split
SPACER
Right
Rear right
Bottom Rear
right left
Bottom left
Do not allow the drain hose to get slack.
insulation, not together.
Packing material
Left
Cut the piping
hole sloped
slightly.