Graco PR70 Instructions - Parts Manual page 8

Installation
17. Pressure transducers (M) are required to work with
the voltage to pressure regulator. See Parts starting
on page 10. If the current PR70 configuration does
not have pressure transducers, refer to the PR70
and PR70v Repair-Parts manual for installation.
See Related Manuals on page 3.
18. A Hydracheck (F) is required to work with the volt-
age to pressure regulator option. See Parts starting
on page 10. If your current PR70 configuration does
not have a Hydracheck, refer to the PR70 and
PR70v Repair-Parts manual for installation. See
Related Manuals on page 3.
19. Connect the power cord and turn on power to the
PR70 at the power switch (J).
20. Load the software from the new programming token.
See the CGA Module Programming manual for
information on loading the new software. See
Related Manuals on page 3.
21. Connect the air line to the air inlet (K).
22. Reattach the shield, and secure it with the shield
locking screws (G).
23. Refer to Startup on page 9 for next steps.
8 3A6225A