Lcd Display; Specifications; General - C-LOGIC 8730 Instruction Manual

Leakage Clamp Meter

2.3 LCD Display

Alternating current or voltage, direct voltage
Diode, continuity
Automatic measuring range mode
Maximum measuring state
Minimum measuring state
Automatic power-off state
Low battery
Reading hold state
Volt(voltage)
Amperes(Current)
Nano, farad, Microfarad, Millifarad
Ohm, Kilohm, Megohm(resistance)
Current clearing state
Temperate measuring state
LPF
Low pass filter (50Hz/60Hz) function state
31
Leakage Clamp Meter

3. Specifications

The meter should be recalibrated under the condition
of 18°C~28°C, relative humidity less than 75% with
the period of one year.

3.1 General

Automatic measuring range and manual measuring
range.
Full measuring range overload protection.
The maximum allowable voltage between
measurement end and ground: 600V DC or AC(RMS)
Operational height: maximum 2000m
Display: LCD
Displayed maximum value: 4000 counts.
Polarity indication: automatical indication, " " means
negative polarity.
Exceeding measuring range display: " O ".
Sampling rate: about 3 times/sec.
Unit display: has function and power unit display.
Auto off time: 30 min
Power supply: 2x1.5V AAA Batteries
Battery undervoltage indication: LCD displays
symbol.
Temperature coefficient: less than 0.1×accuracy/°C
Operational temperature: 18°C~28°C
Storage temperature: -10°C~50°C
Dimension: 213×62×38mm (8.4x2.44x1.5in)
Weight: about 238g(8.4oz)-include battery
-
L
" "
32