Installation Practice; Water Inlet Solenoid Valve - Ice-O-Matic UCG GOURMET Series Installation And Service Manual

12. Has the owner been given the name and the phone number of the authorized Ice‐O‐Matic
Service Agency serving him/her?
G.
INSTALLATION PRACTICE
WARNING: This icemaker is not designed for outdoor installation and will not function in
ambient temperatures below 50˚F (10˚C) and above 100˚F (40˚C). This ice maker will
malfunction with water temperatures below 40˚F (5˚C) or above 90˚F (35˚C).
H. OPERATING INSTRUCTIONS
START UP
After having correctly installed the ice maker and completed the plumbing and electrical connections,
perform the following "start‐up" procedure.
UCG45/65/85/105
A ‐Remove the unit front panel and locate the cleaning switch on the control box.
B‐ Fill Reservoir with cleaning switch in cleaning position (II). This will close the electrical circuit to the
water inlet valve and to the hot gas valve.
C‐ Switch ON the power line disconnect switch. Unit will start up in water filling phase mode. During
this phase the components energized are:
WATER INLET SOLENOID VALVE
HOT GAS SOLENOID VALVE
The Water pump and the F an motor are also in operation.
D‐ Let unit stay in water filling phase mode for about three/four minutes till water is coming out from
the drain hose, then move the cleaning switch to the operation position (I).
UCG GOURMET SERIES UNDERCOUNTER
pg. 6