Husqvarna LF 75 Operator's Manual page 19

2. Fold the wheels (B) down, below the bottom plate.
B
To lift the product
WARNING: Make sure that the lifting
equipment has the correct specification to lift
the product safely. The type plate on the
product shows the product weight.
WARNING: Do not walk or stay below or
near a lifted product.
1. Set the product in transport position. Refer to
the product in transport position on page 13 .
2. Lift the product.
a) If you use lifting equipment, attach the lifting
equipment at the lifting point (A) of the safety
frame. A label on the product identifies the
correct position.
A
18
To safety the product to a transportation
vehicle with tie-down straps
1. Put the handle in transport position. Refer to
To set
2. Put 2 straps (A) around the bottom plate.
B
Storage
•
•
C
•
•
WARNING: Do not lift a damaged
product. Make sure that the safety
frame (B) and the vibration damping
units (C) are correctly installed and
not damaged.
b) If you use a forklift, put the forklift blade (E)
below the 2 straps (D).
E
Note: The straps are standard equipment on
model LF 130 but optional on models LF 75,
LF 80, LF 100
the product in transport position on page 13 .
A
a) Put 1 strap around the front of the bottom plate
and attach the strap to the vehicle.
b) Put 1 strap around the rear of the bottom plate
and attach the strap to the vehicle.
Remove all fuel from the fuel tank before you put the
product in storage for a long period of time. Discard
the fuel at an applicable disposal location.
Clean the product before storage. Remove oil and
dust from the rubber parts.
Clean the air filter before storage.
Carefully pull the starter rope handle until there is a
small resistance. This closes the valves and makes
D
To set
945 - 003 - 03.04.2020