Connection To The Drone; Commissioning Of The Electronics Unit - KTS-Electronic GPA 3000 DR User Manual

3.1 Connection to the drone

If you want to connect the GPA 3000 DR to the drone, you should connect it to the
upper part of the electronics unit (connection to the drone).
The electronics unit has a transmitter antenna which sends search data to the
receiver. Attached to the tablet is the receiver, which receives the transmitted data and
transmits it to the tablet. This tablet with the radio station should be located next to the
remote control of the drone, so you can control the search data.
When searching with the drone, the supersonic probe should be fixed so that the
probe is perpendicular to the ground.
Abb.3.2 Tablet with radio receiver
Note: When connecting the tablet with the radio station, you should first put the
cables in the radio station and then connect with tablet

3.2 Commissioning of the electronics unit

 After switching on the electronics unit via the on / off switch, select one of the
four display languages.
KTS-Electronic GmbH & Co. KG – GPA 3000 DR
Abb.3.3 Radio receiver attached with
Velcro on the backside of the tablet
Fig. 3.4 Language selection
9