PEP CP380 Manual page 35

CP380
3. Configuration
3.1 Jumper Settings
The boards of the CP380 family are Plug and Play compatible under Windows NT and
are configured by software. There are no settings required before installing the board
into the computer.
3.2 Pinouts
The CP380-I front panel is provided with a 25-Pin DSUB male input connector, the
CP380-O with a 25-Pin DSUB male output connector.
Figure 3-1: Pinouts of the CP380-I Input Connector (Left) and the CP380-O Output
Connector (Right)
The CP380-I/O front panel is provided with two connectors, an upper and a lower 15-pin
DSUB male connector.
ID 19313, Rev. 0100 ® PEP Modular Computers GmbH
Configuration
Page 3 - 3