Operation - Bestway Swim Bright Manual

Read the manual and follow the instructions relating to safety tips, correct and
complete product assembly, setting into service, use and maintenance.
For your own safety, always heed the advice and warnings in these
instructions.
Non-compliance with these operating instructions may expose you to serious
danger. Only use the product in the places and conditions for which it is
intended.
• ATTENTION! NO PROTECTION AGAINST DROWNING!
• SWIMMERS ONLY!
• Full inflate all air chambers.
• Passenger numbers and load weight shall by no means exceed passenger
number and maximum weight capacity in specifications.
• This product should not be used as life saving device.
• Life saving device (life jacket and life buoy) must be prepared together and
inspected.
• Keep away from flames and fires.
• Before every use, carefully inspect all product components, to ensure
everything is in good condition and tightly secured. Please stop to repair if you
find any damage.
• Be careful when landing on the ground. Sharp and rough objects such as
rocks, cement, shells, glass, etc. may punctured the product.
• Don't leave the product exposed to sun for long periods of time, as high
temperatures shall give rise to air expansion, which can cause irreparable
damage.
• Never leave in or near the water when not in use.
• Evenly distribute loads when use the product. Tipping and drowning may
occur with uneven distribution of loads.
INFLATION
1. Before using the product, carefully check if there are any leaks or broken
parts.
Open safety valve and inflate with the air pump (not include) to design
working pressure on the product.
2. Fill the chambers until most of the wrinkles are gone and it feels firm to touch
but NOT hard. If you use other pressure gauge, the pressure should not be
more than the specified pressure on the product or on the instruction. Do not
over-inflate the product. Do not use an air compressor.
NOTE: Under and over-inflation of the product will result in safety hazards. It
is better to check the pressure of the product each time before using.
3. Be sure to close the valves after inflation, press in the safety valves after
inflation.
NOTE: Never stand on or rest objects on the product during inflation. Always
check product for leaks before use.
DEFLATION
Open and pinch the bottom of the valves to deflate.
MAINTENANCE AND STORAGE
1. After deflation, use a damp cloth to gently clean all surfaces.
NOTE: Never use solvents or other chemicals that may damage the product.
2. Store in a cool, dry place and out of children's reach.
3. Check the product for damage at the beginning of each season and at
regular intervals when in use.
REPAIR
If a chamber is damaged use the provided repair patch.
1. Clean area to be repaired.
2. Carefully peel patch.
3. Press patch over area to be repaired.
4. Wait 30 minutes before inflation
LED LIGHT
DC 4.5V Max. 0.96W IP67
WARNING
READ AND FOLLOW ALL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
The light source of this device is not replaceable; when the light source
reaches its end of life, the whole device shall be replaced.
The external flexible cable or cord of this device cannot be replaced. If
damaged, the device should be destroyed.
Use only under competent supervision.
BATTERY PRECAUTION
• Do not mix old and new batteries.
• Do not mix the different types of batteries. Do not mix alkaline, standard
(Carbon - Zinc), or rechargeable (Nickel - Cadmium) batteries.
• Ensure batteries are installed correctly with regard to polarity (+ and -).
• Do not short-circuit the battery.
• Never attempt to recharge primary batteries as this may cause leakage, fire,
or explosion.
• Rechargeable batteries are to be removed from this product before being
charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Never attempt to disassemble or open batteries as this can lead to electrolyte
burns.
• Remove batteries from equipment which is not to be used for an extended
period of time.
• Exhausted batteries are to be removed from this product.
• Do not dispose of product and its batteries in fire. Check your local regulations
for proper disposal instructions.
• Batteries shall not be exposed to excessive heat such as sunshine, fire or the
similar.
• Only use AAA batteries (not included).
WARNING
INSTALLATION
WARNING-THIS LIGHTING CHAIN MUST NOT BE USED WITHOUT ALL
GASKETS BEING IN PLACE.
ENSURE BATTERIES ARE INSTALLED WHILE OBJECT IS DEFLATED.
TIGHTLY SCREW ON THE LED LIGHT COVER.
1
2

OPERATION

1. Press the power button and the LED light turns on and alternates between 7
colors.
2. Press the power button again, the LED light turns off (2 hours auto power-off
feature on the product).
MAINTENANCE AND STORAGE
Store in a dry place when not in use.
Please remove the batteries if not in use for a long time.
Use a dry cloth to clean the surface.
Do not drop the product or it may break.
DISPOSAL
MEANING OF CROSSED-OUT WHEELED DUSTBIN:
Waste electrical products should not be disposed of with household
waste. Please recycle where facilities exist. Check with your local
authority or retailer for recycling advice.
5
3
4
5