Sand Filter Maintenance; Section Iv: Complete Sand Filter Installation Connect The Second Hose; Section V: Sand Filter Operation - Bestway Flowclear 58367E Owner's Manual

IMPORTANT:
the sand filter immediately if water levels near the pool's Inlet and Outlet valves.
DO NOT DRY RUN THE SAND FILTER.
Section IV: Complete Sand Filter Installation
Connect the Second Hose
NOTE:
It is imperative to check that the hydraulic connectors are not obturated.
NOTE:
Ensure the Control Valve is set to the Closed function.
Assemble your product referring to Fig. A-2 if there is a T-joint (Fig. E), and referring to B-2 if not. The assembly methods are
the same.
1.Detach the Hose (23) from Port D.
2.Attach the Hose (23 )to the Control Valve's Port A ; screw the threaded locking ring into position.
3.Connect the other end of Hose (23) to the pool's Inlet A.
4.Open the connection valve.
NOTE:
You can refer to pool manual for connection valve's installation instructions.
23(1.5m)

Section V: Sand Filter Operation

1. Now the sand filter is ready for use. Set the Control Valve to the Filter function.
NOTE:
To prevent the risk of electrical shock dry any excess water from yourself and the
sand filter.
2. Switch on the sand filter to run it.
NOTE:
The sand filter has now started its filtering cycle. Check that water is returning to
the pool and take note of the filter pressure on Pressure Gauge. Generally, the recommended
sand filter pressure is less than 0.56Bar (8.0PSI) when it is running.

Sand Filter Maintenance

CAUTION:
maintenance begins or severe risk of injury or death exists.
As dirt builds up in the sand filter, the pressure reading on Pressure Gauge will increase. When
the Pressure Gauge is 0.56Bar (8.0PSI) or higher, or water flow to the pool is too low, it is time to
clean the sand.
To clean the sand bed, follow all instructions outlined previously in Section II and Section III:
Backwash and Rinsing.
NOTE:
1. The Pressure Gauge is just used for measuring the water pressure, not used for precision
measurement.
2. We recommend you clean the sand bed once a month or less regularly depending on how
often the pool is used.
Do not clean the sand too frequently.
S-S-004040/21.0x28.5cm (#58367E 2000gal 美国规砂滤器说明书) JS-YF-2015-B-06507
This procedure removes water from the pool, which you'll need to replace. Switch off
B
B
A
23 (1m)
Fig.A-2
B
You must ensure the sand filter is switched off and unplugged before any
B
A
A
23
23
Fig.B-2
B
8
Water level
>1.2 inch
Liner
10
15
5
20
23
0
psi
bar
10
15
5
20
23
0
psi
bar
S-S-004040