Drup - Datarate Up; Chdw - Channel Down - IDEETRON LoRaWAN Manual

8.3 DRUP – Datarate up
This command is used for the datarate that is used on the up channel of the LoRaWAN
communication, see Figure 1.
To set the datarate use:
#DRUP[Datarate]
The [Datarate] values are listed in Table 6.
The reply will be:
*DRUP [Datarate Description]
To request the current datarate use:
?DRUP
The reply will be:
=DRUP [Datarate Description]
8.4 CHDW – Channel down
This command is used for the channel that is used on the down channel of the LoRaWAN
communication, see Figure 1.
To set the channel use:
#CHDW[Channel]
The [Channel] can have the following values
The reply will be:
*CHDW [Channel Description]
To request the current channel use:
?CHDW
The reply will be:
Value Channel (MHz)
00 868.100
01 868.300
02 868.500
03 867.100
04 867.300
05 867.500
06 867.700
07 867.900
10 869.525
Table 7: Channel values
Pagina 8 of 12
LoRaWAN mini gateway
1-11-2016