Table of Contents
Advertisement
Quick Set-Up Guide
The following basic steps enable quick and easy installation of your new
Cobra Intenna Cordless Phone for use on a desk or countertop. You are
encouraged to review this complete instruction manual to become familiar
with all of the operating instructions and features of your new phone.
NOTE: Before using, connect your new system to AC power (see instruc-
tions below) to charge it overnight (at least 12 hours) for optimum condi-
tioning of the rechargeable battery inside the cordless handset.
1
Insert round connector of power adapter into POWER jack (at rear of
cordless phone's base; see diagram #1 below). Plug power adapter into a
standard 120 VAC household electrical outlet. Then place handset in
base so CHARGE indicator lights (see p. 12).
BASE UNIT—
REAR VIEW
ON/OFF
RINGER SWITCH
ELECTRICAL
OUTLET
2
After charging, remove the twist-tie from the phone cord and plug the
modular telephone connector into the phone jack on your wall (see above).
Make sure that the RINGER switch is ON (located on base; see p. 11 for
3
details).
4
Set the PULSE/TONE switch (at the rear of
the base) for proper operation (see page 11
for details).
Note: Make sure you have charged handset
in base 12 hours before using.
5
Install the 9V battery for Power Protector™
operation in the base as shown in the
illustration.
2505.MANUAL.pm
PULSE/
RINGER
TONE
POWER
OFF ON P
T
9V DC
4
PULSE/TONE
SWITCH
ADAPTER
6
7
HANDSET
Diagram #1
Connecting
power and
telephone
DC POWER JACK
2
MODULAR
PHONE JACK
11/7/97, 11:43 AM
Advertisement
Table of Contents
