Advertisement
Manual: Laserworld EL-200 LED
Maintenance / cleaning
Always disconnect from the mains when the device is not in use or before cleaning it.
Open the device by removing the screws on the front panel, remove connector. Remove any
deposits of dust, especially at the fan. Check for condensed fog fluid inside, if so, clean and
rearrange the position of laser and or hazer.
noticeable around the beam, or an unusual high amount of diffuse light can be seen inside
the
device.Clean the mirrors with window cleaner and a paper towel.
Never look directly into the light source. Always disconnect from the mains when
the device is not in use or before cleaning it.
Troubleshooting
Problem
No function / fan not working
Effects don't change to the beat of the music Adjust sensitivity with the dial on the front.
Problems with DMX control
Device not working, but fan working
Technical specifications
•
Power supply: AC 85V-260V, 50/60 Hz
•
Ambient temperature: +10°C ... +35°C
•
Power consumption: 40 W
•
Operation modes: DMX 512, automatic, music mode
•
Lasersources: aircooled DPSS laser
•
Optical power (at the laser): max 200mW; >40mW 532nm green, >110mW 650nm
red
•
Beam: ca. 3mm/1mrad
•
Laser class: 3b
•
Scanning system: fast stepper motors ca. 2-5 kpps
•
LED: 3W RGB
•
Weight: 2.6 kg
•
Dimensions:
Please note
This device has left our premises in absolutely perfect condition. In order to maintain this
condition and to ensure a safe operation, it is absolutely necessary for the user to follow the
safety instructions and warning notes written in this user manual.
Laserworld cannot be made liable for damages caused by incorrect installations and unskilled
operation!
This manual is subject to changes without notification. Contact your local dealer for an
update, or check our website www.laserworld.com
25 – 49
Laser on LED flashes
50 - 74
Laser, LED flash alternating
75 – 124
Laser, LED flash synchronous
125 – 174
Both on
175-199
LED only
200-224
Laser only
225-249
Both off
250 - 255
Normal operation
7
0-255
Colour LED
360x114x118 mm
Mirrors need cleaning, when a "halo" is
Possible cause
Check mains connection
Check if device isn't in DMX or autom. mode
Check DMX address selection
Turn device off for ca. 1 Minute.
(W x D x H)
Page 5 of 6
Date: 08/2009
Advertisement
