User Manual: V PRO-OEM
6
7
8
9
10
11
12
13
14
15
16
17
18
Maintenance / cleaning
Always disconnect from mains before cleaning/opening the laser. Regularly clean the interior
from dust, especially ensure operation of the fans. Use a sponge with alcohol, rather than
wet cloth or other chemical liquid, to clean the mirrors. Be careful, even light scratches
reduce the output power of the laser. Mirrors need cleaning, when a "halo" is noticeable
around the beam, or an unusual high amount of diffuse light can be seen inside the device.
Technical specifications
•
Modes: ILDA, DMX 512, auto, music active
•
ILDA: 25pin ILDA standard Sub-D shaped 25pin connector
•
Galvos: 50k scanspeed
•
DMX 512: 14 channels
•
Patterns: 160
•
Scanangle: set to ca. 40° optical (60° max)
•
Beam: ca. 3mm/1mrad
•
Accessories: power cable, key switch, interlock plug, manual, safety cord
•
The laser comes in a flightcase.
•
Input voltage: AC 100~240V 50/60Hz
•
Power consumption: 450W
•
Size: 670 x 370 x 440 mm (W x D x H)
•
Weight: 30kg Laser, total: 50kg (with
flightcase)
•
Operating temperature: 10°-35°C
(below 20°C the power may be reduced)
Change scanner
1. Unscrew UK M6 screws and disconnect signal
cable.
2. Loosen M4 x 10 screw and remove galvo.
3. Insert galvo, reconnect and fix signal cable.
4. Rotate galvo to centre projection. Fix galvo.
Adjustable mirror mounts
1. Loosen setscrews, then adjust with X/Y
adjustable screws. Make sure beam is centred
on scanner mirrors.
2. Adjust Z-screw simultaneously.
3. Tighten setscrews.
Pattern
Horizontal rotation
Vertical rotation
Rotation about Z-axis
Horizontal movement
Vertical movement
Horizontal size
Vertical size
Hor. and vert. size
Drawing speed
Point draw
Scanspeed
Pattern size
0~255
160/5=32pcs
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~255
slow to fast
0~1
Original size
2~255
Size (120=original)
Page 5 of 8
Stand: 03/2010