Honda XRM125 CFT125 2020 Owner's Manual page 80

Tyre Puncture Removing Wheels
u
Installation
Attach the side collar and speedometer
1.
gearbox to the wheel.
Position the wheel between the fork legs
2.
and insert the front axle shaft from the
right side, through the right fork leg and
wheel hub.
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Make sure that the lug on the left fork leg
3.
is located in the slot of the speedometer
gearbox.
Tighten the axle nut.
4.
Torque: 49 N·m (5.0 kgf·m, 36 lbf·ft)
76
After installing the wheel, apply the brake
5.
lever several times, then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel dose not
rotate freely.
Install the speedometer cable securely.
6.
Speedometer gearbox
Lug
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Slot