Honda CMX500A 2019 Owner's Manual page 109

Remove the rear axle shaft, chain
5.
adjusting plates, brake caliper bracket,
rear wheel and side collars.
Support the brake caliper assembly so
u
that it doesn't hang from the brake
hose. Do not twist the brake hose.
Avoid getting grease, oil, or dirt on the
u
disc to pad surfaces.
Do not push the brake pedal while the
u
wheel is removed.
Installation
Attach the right and left side collars in
1.
their original locations on the rear wheel.
To install the rear wheel, reverse the
2.
removal procedure.
Take care to prevent the brake caliper
u
from scratching the wheel during
installation.
Tyre Puncture
NOTICE
When installing a wheel or caliper into original
position, carefully fit the brake disc between the
pads to avoid scratching them.
Make sure that the lug on the swingarm is
3.
positioned in the slot on the brake caliper
bracket.
Brake caliper bracket
Removing Wheels
u
Lug
Slot Swingarm
Continued
105