Haier HW80 User Manual page 25

EN
Problem
Excessive foam
floats drum and/or
detergent drawer.
Automatic adjust-
ment of washing
time.
Spinning fails.
Unsatisfactory
washing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor will run at low speed for 30s and
repeat at most 4 times. After that, If too much foam was detected, the motor will stop
for 5min, 10min, and 15min in sequence.
Should the error messages reappear even after the taken measures, switch o the appli-
ance, disconnect the power supply and contact the customer service.
9.4 In case of power failure
The current programme and its setting will be saved.
When power supply is restored operation will be re-
sumed.
If a power failure cuts an operating wash programme
door opening is mechanically blocked. To get out any
laundry water level should not be seen in the glassy
porthole of the door. - Danger of burns! Water level
has to be lowered as described in "Pump lter". Not till
then pull lever (A) beneath service flap (Fig. 9-1) until
door is unlocked by a gentle click. Afterwards re x all
parts.
Cause
• Detergent is not a appropriate.
• Excessive use of detergent.
• Washing programme duration will
be adjusted.
• Unbalance of laundry.
• Degree of pollution does not agree
with selected programme
• Detergent quantitiy was not suf-
cient.
• Maximum load has been excee-
ded.
• Laundry was unevenly distribu-
ted in the drum.
• Insoluble particles of detergent can
remain as white spots on the laun-
dry.
• Caused by fats such as oils, creams
or ointments.
9-Troubleshooting
Solution
• Check detergent recommen-
dations.
• Reduce amount of detergent.
• This is normal and doesn't af-
fect functionality.
• Check machine load and laun-
dry and run a spinning pro-
gramme again.
• Select an other programme.
• Choose the detergent acc.
to the degree of pollution
and acc. to manufacturer
speci cations.
• Reduce loading.
• Loose the laundry.
• Perform extra rinse.
• Try to brush the points from the
dry laundry.
• Choose an other detergent.
• Pretreat the laundry with a spe-
cial cleaner.
If still, spinning cycle will stop by displaying error.
9-1
25