Table of Contents
Advertisement
16. Attentions:
15.1 Check whether the power supply is loaded before exercising; Check whether the
safety key does work.
15.2 During the exercise, you can pull out the safety key in the abnormal situation, the
treadmill will quickly slow down to stop. Then insert the safety lock, reset the device,
and wait to input instructions.
15.3 If there is any problem, please contact with the dealer. For non- professional staff,
please do not try to remove or repair to avoid damage to the equipment.
17. Meanings of error message codes:
Error code
E01
Inverter communication fault
E03
Over voltage
Over current
E04
Over loading
E05
E06
E07
The inverter over heating
E08
The inverter cannot receive
signals from the display
E09
The inverter internal
communication error 1
E10
The inverter internal
communication error 2
Received a power-on signal,
E11
but before that, never
received any power-off
E14
Inverter phase loss
E15
E16
Exception
The connecting wire of computer and
controller is broken
The joint is loosen
external AC over voltage
Inverter fault
The transmission part is stuck
The inverter parameters do not match
the motor
User's weight over the max weight
Running belt is short of oil
The inverter broken
MCU fault
The inverter broken
The inverter fan mouth is blocked
The inverter fan broken
Communication wire broken
Computer broken
board
Inverter broken
Inverter broken
Inverter broken
Communication is interrupted
Program disorder
signal.
Check the connection of motor wire and inverter
Possible reasons
- 19 -
Solution
Replace the connecting
wire
Connect the joint again,
make sure it is connected
Make sure the external
voltage is below 270V
Replace the inverter
Replace the parts
Replace the inverter
Add the lubrication
Replace the inverter
Replace the inverter
Clean up sundries
Replace the inverter
Replace the wire
Replace the computer
Replace the inverter
Replace the inverter
Replace the inverter
Restart power supply
Replace the inverter
Advertisement
Table of Contents
