Installation manual e-MatriX heat 800/500 RD,ST (LL) Dear user Standard Electromagnetic Compatibility (EMC) EN55014, EN60555-2 and EN60555-3 these cover Congratulations on your purchase of a Faber fire! A the essential requirements of EEC Directives quality product from which you will experience 2006/95/EC and 2004/108/EC warmth and atmosphere for many years.
Page 10
Installation manual e-MatriX heat 800/500 RD,ST (LL) Placing the fire Water connection For a proper functioning of the fire, always ensure This appliance is equipped with the following that the fire is levelled. (overflow) protections: Electromechanical valve in the Control...
Installation manual e-MatriX heat 800/500 RD,ST (LL) Remove both glass springs at the top. See Lift up the fuel bed carefully, disconnect fig. 2.2a. the plug and store it at a safe place, see fig. 3.0b. Place the suction cups and remove the front glass.
Installation manual e-MatriX heat 800/500 RD,ST (LL) Place the fuel bed, see chapter 6. Cleaning mesh filter and replacing in-line Place the front glass, see section 5. filter. Commercial use: Replacing transducers once a year. Domestic use: Please note! every second year.
Page 13
Installation manual e-MatriX heat 800/500 RD,ST (LL) 11 Troubleshooting and fault codes remote control Code Symptom Cause Action The flame effect will not No power supply. Check if power supply is connected to wall start. socket correctly and the mains switch of the Control box is in the ON (I) position.