Error Codes; Error Message - Ryobi Roboyagi Troubleshooting Manual

ERROR CODES

ERROR
00-30 Critcal error
29, 32 No boundary wire signal detected
33-36 My Area Sensor has stopped
working.
37 I am outside of boundary wire.
38 My Bump Sensor has an alert.
39 My lift sensor has been triggered.
40-41 My tilt sensor has been triggered.
42 I am unable to leave the charging
station.
44 I am stuck.
45 Lift Recovery Failure.

ERROR MESSAGE

SOLUTION
Restart the mower (turn off, then turn on).
If issue persists, contact an authorised RYOBI service
centre.
Ensure that ROBOYAGI is within 28 m of a wire.
Ensure that the wire is connected securely to the terminals
on the charging pad (T1,T2).
Ensure that the boundary wire loop is closed.
Restart the mower (turn off, then turn on).
If issue persists, contact an authorised RYOBI service
centre.
Place the mower back in the charging station.
Restart the mower (turn off, then turn on).
If issue persists, contact an authorised RYOBI service
centre.
Ensure that the mower is placed within the boundary wire
loop.
Please refer to the Setup sheet or the "Installing the
charging station and boundary wire" section of the manual.
If issue persists, switch the wire connections on the
charging station terminals (T1, T2).
Check that ROBOYAGI is not stuck, move to a new area
and restart the mower.
If issue persists, contact an authorised RYOBI service
centre.
Check that ROBOYAGI is not stuck against an obstacle,
move to a new area, and restart the mower.
If issue persists, contact an authorised RYOBI service
centre.
Check that ROBOYAGI is not tilted or upside down.
Place ROBOYAGI on a flat surface, and restart.
Check that all slopes are within 20°.
If issue persists, contact an authorised RYOBI service
centre.
Check that the route in/out of charging station is not
obstructed.
Check that ROBOYAGI's charging socket is not stuck
against the charging station port .
Ensure that the charging pad is positioned on a flat ground.
If issue persists, contact an authorised RYOBI service
centre.
Check that the mower is not stuck in a hole, and that the
rear wheels are touching the ground.
Ensure that any holes in the lawn are filled to prevent the
mower from getting stuck.
If issue persists, contact an authorised RYOBI service
centre.
Check that ROBOYAGI is not stuck against an obstacle,
move to a new area, and restart the mower.
If issue persists, contact an authorised RYOBI service
centre.
Original Instructions
5
English