Starting The Phone; Basic Call Functions - Verizon One Talk T57W User Manual

Starting the phone

After the One Talk phone is connected to a network and
supplied with power, it will automatically begin the initialization
process. The phone will go through a series of screens and
update the firmware on the device; the first-time setup process
takes about 15 minutes and should not be interrupted. You will
know the phone is ready for use when the 911 address appears
on the screen of the device.

Basic call functions

Placing a call
Using the handset:
1. Pick up the handset
2. Enter the number, and then tap Send
Using the speakerphone:
1. With the handset on-hook, press
2. Enter the number, and then tap Send
Using the headset:
1. With the headset connected, press
headset mode
2. Enter the number, and then press Send
Note: During a call, you can alternate between the headset,
hands-free speakerphone and handset modes by pressing
the Headset key, the Speakerphone key or by picking up the
handset. Headset mode requires a connected headset.
Answering a call
Using the handset:
Pick up the handset.
Using the speakerphone:
Press .
Using the headset:
Press
Note: You can reject an incoming call by pressing Reject.
Ending a call
Using the handset:
Hang up the handset or press End Call.
Using the speakerphone:
Press
Using the headset:
Tap End Call.
Redialing a call
• Press
• Press
Muting and unmuting a call
• Press
• Press
Holding and resuming a call
To hold a call:
Press
To resume the call, do one of the following:
• If there is only one call on hold, press
• If there is more than one call on hold, select the desired call,
Transferring a call
You can transfer a call in the following ways:
Direct transfer
to activate the
1. Press the Direct soft key during an active call. The call is
2. Enter the number you want to transfer to
3. Press the Direct soft key
Consultative transfer
1. Press the Consult soft key during an active call. The call is
2. Enter the number you want to transfer to, and then
3. Press the Consult soft key when you hear the
.
or End Call.
to enter the Placed Calls list, and then tap the
desired entry
twice when the phone is idle to dial out the last
dialed number
to mute the microphone during a call
again to unmute the call
or Hold during an active call.
and then press or Resume
placed on hold
placed on hold
press
ringback tone
User guide
or Resume
3