Flex FX2221 Operator's Manual page 14

DUST COLLECTION PORT
The dust collection port on this jig saw is
compatible with Ø 32mm vacuum hoses or
adapters to connect a vacuum cleaner.
Installation:
Align the dust collection port as shown and
insert the hook of the dust collection port into
the slot in the base, push the dust collection
port backward and tighten the clamp screw at
the front of the dust collection port (Fig. 15).
The dust collection port can be mounted on
either right or left side to accommodate cutting
at different angles of the base. Make sure that
the dust intake opening is facing the blade.
Disassembly:
Loosen the clamp screw and push the dust
collection port slightly forward to remove it
directly (Fig. 16).
Fig. 15
Clamp Screw
Fig. 16
-14-
Hook