Luowice WS9004CH-4C Manual

Luowice WS9004CH-4C Manual

How to set the repeater mode

Advertisement

Q: How to set the Repeater Mode
A:
1. Before repeater setting, please kindly put all your four cameras
next the NVR. Before repeater setting is done, the repeater setting
requires four cameras with strong signal. Or you can put the NVR
near the camera, after finish setting, you can put the NVR back to the
original place. If the cameras are far away from the NVR, then the
repeater setting may fail. If you have already installed the cameras
outsides or on wall, please kindly put them off, plug them and put
them next to the NVR to setup the repeater.
2. Please remember the camera's corresponding channel in the NVR.
When beginning the repeater setting, connect the cameras which are
further away from the NVR with the camera closer to the NVR.
Function: Apply the WiFi Booster Technology. Once setting up, the
cameras will also work as Signal Transfer Device. The cameras
further to the NVR will transmit signals to the camera closer to the
NVR first, and then the closer camera will transmit the signals back to
the NVR. The technology doubles/triples the current WiFi distance
theoretically.

Operation:

Step 1. Right click the mouse, click ' Video Manage' - Click
"Repeater". And you shall see the below image.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WS9004CH-4C and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Luowice WS9004CH-4C

  • Page 1 Q: How to set the Repeater Mode Note: 1. Before repeater setting, please kindly put all your four cameras next the NVR. Before repeater setting is done, the repeater setting requires four cameras with strong signal. Or you can put the NVR near the camera, after finish setting, you can put the NVR back to the original place.
  • Page 3 Step 2. Click the “+”icon behind the channel that you want to use it as signal transfer device, then choose the channel that you want to connect to the previous channel. E.g. Click “+” behind CH2, and choose “3” (Refers to CH3), Then CH1 and CH2 can lose connection for seconds and reconnect automatically.
  • Page 4 Step 3. Click “Refresh” to check whether the WiFi Booster Technology is applied successfully. If it works, the further channel shall show stronger WiFi signal than before. If yes, click “Apply” to save all the changes. Note: a) If you want to apply the technology to multiple cameras, please build one camera at a time to avoid system freeze up.

Table of Contents