Download Print this page

Luowice WS9004CH-4C Faq

Download this manual

Q: How to fix the No video problem

1.Disconnect power from the No video camera

and reinsert the power

2.Check the channel rate

Step 1

Right click on screen and choosing the video manage

then choosing the WIFI setup on this setting page.

Step 2

Adjust the WIFI channel to get a stronger

connection. we recommend that using the WIFI

channel 2, 6, 11 or 13 which can get a strongest

Need help?

Do you have a question about the WS9004CH-4C and is the answer not in the manual?

Page 1 Q: How to fix the No video problem 1.Disconnect power from the No video camera and reinsert the power 2.Check the channel rate Step 1 Right click on screen and choosing the video manage then choosing the WIFI setup on this setting page. Step 2 Adjust the WIFI channel to get a stronger connection.
Page 2 channel rate,(if the rate a lower then 25 may loose the picture) 3. Try to restore the camera to factory settings and re-pair with the NVR. Step 1: Download Factory tool “IPCamsuite” From http://www.dvr163.com/, enter help page, Choosing Tool software ,click “IPC Computer Search Upgrade Tool”.
Page 3 Step 2: Connect the cameras that you want to factory setting to the same router with your computer.
Page 4 Step 3: Open the “IPCam suite” on your computer , then click refresh, and wait seconds, you can find the camera, then select the camera that you want to factory and click FactoryReset, and then it will show “success” and prompt “complete factory reset”...
Page 5 Step 4: pair the camera to the NVR You can refer to the Q&A “How to pair the cameras(N1 protocol) to the monitor”...