Remote Control Battery - Kayoba 012288 Operating Instructions Manual

CHASSIS
1. Motor
2. Power switch
3. Lithium-polymer battery
4. Jack for lithium-polymer battery
FIG. 3
ASSEMBLY

REMOTE CONTROL BATTERY

1. Open the battery compartment on the
underside of the remote control.
2. Insert 3 non-rechargeable 1.5 V AA
batteries. Make sure to insert the batteries
with the correct polarity.
3. Replace the battery cover.
FIG. 4
USE
CHARGING THE CAR
1. Switch off the car.
2. Remove the spring pins on the body.
3. Release the body.
4. Remove the spring pin on the battery
holder and remove the battery.
5. Connect the USB cable to a USB port on
a computer or a compatible network
adapter.
6. Connect the charger cable to the lithium-
polymer battery for the car.
7. It takes about 3.5 hours to charge the
battery. Do not charge the battery for
more than 4 hours – risk of overheating.
– The red status light goes on when
the USB connection is supplied with
voltage.
– When the battery is inserted/
connected the green status light
flashes and the red status light is
constant.
– When the battery is fully charged
both status lights are constant.
8. Remove the battery from the charger and
put it in the car.
NOTE:
• First connect the USB cable to a USB port
on a computer or a compatible network
adapter, and then to the battery.
• The charging time varies, depending on
the charge status of the battery.
• After use, allow the battery to cool for
10-15 minutes before charging.
WARNING!
Do not leave the battery unattended when
charging – risk of overheating.
PREPARATIONS BEFORE DRIVING
1. Put the power switch on the car in the ON
position.
2. Put the power switch on the remote
control in the ON position to activate the
remote control. The green status light
goes on. If the status light does not go
on, check that the batteries are correctly
inserted and in good condition.
3. After use, first switch off the car and
then the remote control. Always remove
the battery from the product after use.
If the battery is left in the product it will
discharge and can be damaged.
NOTE:
Start the product first and then the remote
control to establish communication between
the units.
EN
27