Inserting The Battery - Kayoba 023907 Original Instructions Manual

FIG. 2
ASSEMBLY

INSERTING THE BATTERY

Radio controlled car
1. Check that the power switch is switched
off.
2. Undo the screw.
3. Remove the battery compartment cover.
4. Insert the batteries as shown in the figure.
5. Replace the battery compartment cover
and tighten the screw.
Remote control
1. Check that the power switch is switched
off.
2. Press the screw hole with the screwdriver
and pull out the cover.
3. Insert two AAA batteries with the correct
polarity as shown by the markings in the
battery compartment.
4. Push back the battery cover.
FIG. 3
USE
Driving forward
Move the left and right lever on the remote
control up at the same time.
FIG. 4
Driving backwards
Move the left and right lever on the remote
control down at the same time.
FIG. 5
Right turn
Move the left lever up.
FIG. 6
Left turn
Move the right lever up.
FIG. 7
360° right turn
Move the left lever up and the right lever down
at the same time.
FIG. 8
360° left turn
Move the left lever down and the right lever up
at the same time to turn 360° to the left.
FIG. 9
Turning 180°
Move the left and right lever up at the same
time and then move both levers down at the
same time.
FIG. 10
NOTE:
• High buildings and walls etc. can
interfere with the radio signal. Magnetic
fields around high voltage cables or
signals from other transmitters can also
interfere with the signal.
• Replace or charge the batteries when
the stunt car looses power or cannot be
steered.
EN
15